[MATERIEL] Dual H Bridge DC Stepper Motor

Dual H Bridge DC Stepper Motor Drive Controller Board Module Arduino L298N

Feature

• Good chip: L298N as main chip, ST corporation production.low heat,outstanding anti-interference performance.high working power to 46v,large current can reach 3A MAX and continue current is 2A, power to 25w. can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors.
• Built-in 78M05,get power from drive power,however, when drive power over12V, please use the external 5v power as power supply.
• Large capacity filter capacitance,afterflow protection diode, more stable and reliable.

Specification:

• Double H bridge drive
• Chip L298N (ST NEW)
• Logical voltage 5V
• Drive voltage 5V-35V
• Logical current 0mA-36mA
• Drive current 2A(MAX single bridge)
• Storage temperature -20 to +135
• Max power 25W
• Weight 30g
• Size:43*43*27mm

Note:

• This module has a built-in 5v power supply, when the driving voltage is 7v-35v, this supply is suitable for power supply, DO NOT input voltage to +5v supply interface, however ledding out 5v for external use is available.
• When ENA enable IN1 IN2 control OUT1 OUT2
• When ENB enable IN3 IN4 control OUT3 OUT4

- Environ 3€